This may be the time you aim right at the pin or try to carry a hazard that you might normally play around. This trope usually makes a golfer play a ball in a place where nobody in the real world would. I was real happy with the quality of this artificial putting surface. Before the artificial putting surface could be attached to the putting lane, I had to finish the attachment design as explained in the next section. Once dried, the filler was sanded and smoothed to blend with the surface of the putting lane plywood so there was no interference to the smooth rolling of a putted golf ball. This will allow for the easy rolling and return of the putted golf ball. Both ends of the right alley are left open so the return golf ball flows freely to be reused again. There are a few archaeological sites close to the camp and pot shards and bone fragments have been unearthed here.

An empty field except for a few people with raised metal clubs? Volkswagen likes to keep people guessing with this one, changing its name multiple times from Rabbit to Golf and back again. One hundred people lost their lives that day in the deadliest wildfire in the U.S. Even though modern sanitary landfills are safer and less of a nuisance than the open dumps of the past, no one likes having a landfill around. Trying to hit the ball harder will not necessarily gain you any distance - in reality, if you try to hit the ball too hard you are more prone to a mis-hit. Keeping your lower body still when you putt will make it much more likely to roll your golf ball on the line you are aimed and also be more consistent controlling distance. Fortunately, regular 2 x 4 inch pine studs are nominal 1 ½ inches thick so I used two pieces of scrap pine to form the roof of each ramp border assembly. A ½ inch wide notch was added to the pattern so the ramp borders could grip the front plywood border of the target assembly.

That means we need 3 inch wood spacers to form the top of the ramp border assemblies. The wood frame side that abuts the target assembly was cut at a 60 degrees angle so the net would be positioned horizontally. As an afterthought, I made an "out-of-bounds" net to catch wayward golf putts that were hit too hard. This net was made to catch the "too-hard" putts. Fast-forward to the present, and in a single day, a pentathlon athlete must first fence all other opponents, swim 200 meters, then ride an unfamiliar horse through a 12-jump course. The curved launch ramp was then attached with wood glue and small brad nails. The finished alley covers set in place on the putting lane assembly up against the launch ramp borders. The borders were needed so the putted ball could stay on target. The height of the alleys were made to match the launch ramp borders.

This gave move then enough height for the returning Srixon golf balls balls to travel freely (by gravity). Disc Golf is played like traditional golf but with disc golf discs instead of balls and clubs. During colder months, opting for balls with a softer compression can be beneficial as they tend to perform better in lower temperatures. They are not permanently attached so they can be removed and stored in the target assembly for transport. There are so many myths amongst golfers on what equipment can and can't do for their games. They may be good fun, but there are hundreds of other ways to liven things up ahead of your next Sunday rollup. There will be more information on the fabrication of the putting lane in the next section. There is no one else to blame or take credit for your performance, only you. Experiencing the Kruger National Park in the comfort of an open safari vehicle remains one of the most popular ways to see the park.